FAQ.ECAT.COM

With your new achievement is it possible to increase the COP?

Asked by Ecat.com  cop increase the cop

Will it be possible to run the household e-cat with a higher temperature, too, in order to produce electricity?

Asked by Ecat.com  electricity household e-cat higher temperature

1. Is most of the heat in the E-Cat produced by the interaction of gamma photons with lead? 2. Are there other minor sources of heat? If so, can you specify? 3. Are neutrons created in the E-Cat? If so, does the lead block them from radiating, or are they too slow to even leave the reaction chamber and pose a threat to human safety?

Asked by Ecat.com  e-cat gamma photons neutrons

Notwithstanding the trade secret, given the nerve-wracking wait for gi worn my trust and that of your supporters, you publish this manual at least on line?

Asked by Ecat.com  trade secret manual supporters

Will it feature a "red button" type of a rapid emergency shutoff system?

Asked by Ecat.com  red button emergency shutoff

I'd like to build a standalone unit, (like a space heater) completly indipendent from the central unit. What type of optional/accessories (radiator, pump, etc) do you suggest to buy together the E-Cat i already ordered? Or may be you just considered a kit. Do you plan to increase the COP in the near future?

Asked by Ecat.com  cop pump radiator

What do you think of Athanor and Brillouin technology? From your experience, these different methods of creating energy can work?

Asked by Ecat.com  energy brillouin technology athanor

Does anyone know if helium formation has actually been observed in a Brillouin reactor (as suggested)? Or, for that matter, in an Ecat?

Asked by Ecat.com  ecat helium formation brillouin reactor

Is Hydrogen used only or is Deuterium (Heavy Hydrogen)used?

Asked by Ecat.com  hydrogen deuterium

Is it possible to know the daily (24h) power consumption in kwh of the E-Cat at 1/3 of its thermal power (3,3kw), 2/3 (6,7kw) and full power (10kw) without considering the 1 hour start-up consumption?

Asked by Ecat.com  e-cat power consumption thermal power

1. Must the E-Cat be cold before the fuel rod can be safely removed? 2. If so, is there a safety mechanism that is incorporated into the E-Cat that will prevent removal at any other time? 3. Will you continue to work at raising the temperature of the reactor from 260C even though you have achieved this important milestone? 4. What do you believe to be the next milestone for the E-Cat?

Asked by Ecat.com  e-cat fuel safety mechanism

1) Is the returned Ni all, or mostly, available to be reused, after reprocessing, in fresh E-Cat charges? 2) Is there a limit as to how many reprocessing cycles a Ni charge can undergo before it becomes unsuitable for use in an E-cat? 3) If the Ni does become unsuitable at some point, presumably it would still be suitable for general industrial use?

Asked by Ecat.com  ni e-cat charges industrial use

Must the E-Cats in the MW plant be turned off when refuelling every 6 months?

Asked by Ecat.com  e-cats mw plant refuelling

In the MW plant, is every E-Cat automatous? That is, is every E-Cat fully independent with its own control unit? If so, do the E-Cats communicate with each other in order to support each other when the need arises? Example: When an E-Cat is close to exiting the self-sustain mode and needs to be charged anew, does it put out a signal to the other E-Cats for help, and do they respond?

Asked by Ecat.com  e-cats self-sustain mode mw plant

Have you switched the 1MW device off, then on again with satisfactory results?

Asked by Ecat.com  1 mw test

What is the temperature of the output that the 1MW reactor is running at?

Asked by Ecat.com  1 mw temperature

Considering that a home-based E-Cat may not be ideally suited to all domestic situations. Is it possible (maybe within 10-20 years) that we could see large, muli-staged, self-sustaining E-Cat power plants that could replace nuclear power plants? If built next to the existing nuclear reactor buildings, they could even maybe utilise the existing turbines/electicity distribution installations.

Asked by Ecat.com  1 mw

Have you ever thought about inductive/rf heating of the ni powder?

Asked by Ecat.com  heating