Andrea Rossi answer questions about the ECAT
What will happen with the lead shield when the reactor overheats by accident? If there are no cooling water flowing and no control system working. The reaction will stop because the temperature goes high and the nickel starts to change composition. There have been mentioned temperatures up to 1500 degC. The lead melting temperature is about 330 degC. Is the lead shield existing during the above described conditions? Are there any danger for the gamma rays?
Asked by Ecat.com nickel gamma rays temperature
I was wondering, if you increased the hydrogen pressure to a very high level, and then initiated a rapid temperature increase greatly above the ignition temperature, do you think a military-type reaction would result, assuming the enclosure could contain the reaction for some period of time?
Asked by Ecat.com temperature reaction hydrogen pressure
1. Does the control unit maintain a COP of 6 for ANY value between 0 and 10 kilowatts of output power, especially in the low end of that range? 2. Theoretically, can a higher COP exist for very small values of output power WITHOUT creating new problems for stability? 3. Is the instability at higher temperatures due to a) the higher speeds of the reactants or b) the higher rate of transmutation?
Asked by Ecat.com cop transmutation temperature
Which of the following entities does the control unit alter in a CYCLICAL manner? A) pressure b) temperature c) fields d) charge flow
Asked by Ecat.com temperature pressure fields
Is the e-cat unable to get to the required temperature or is it that if it does the reaction becomes too violent and unstable?
Asked by Ecat.com e-cat temperature reaction
If you are to have the reactors in series to achieve a higher temperature why not build the group of reactors as one unit? This would reduce the number of pipes and troublesome gaskets?
Asked by Ecat.com temperature reactors technology
What is the temperature of the output that the 1MW reactor is running at?
Asked by Ecat.com 1 mw temperature
If you can tell me, without revealing too much, the estimated steam pressures and temperatures available from a single 3 reactor 30kw unit under varying power settings (if there is more than just one setting),?
Asked by Ecat.com e-cat temperature development
If I am not wrong,the reaction start at 60 °C
Asked by Ecat.com temperature
Why not use a chemical reaction (which can be very powerful in a short time) to create the right temperature to achieve self sustenance of 'cat and that could be triggered by a cartridge inserted into the system and be ejected at the end of the task by the system itself.
Asked by Ecat.com e-cat temperature self sustaining