Andrea Rossi answer questions about the ECAT
What would happen if I had a power failure in my home such that the ecat controls AND the (cooling-) water pump stops. Would the ecat overheat? Would it be reusable?
Asked by Ecat.com water pump ecat home
What would happen if I had a power failure in my home such that the ecat controls AND the (cooling-) water pump stops?
Asked by Ecat.com water pump ecat home ecat
Domestic E-Cat will be delivered with differents heat exchanger: Boiler for hot water, heat exchanger for hot air, full cupper electrode to replace steatite water heater?
Asked by Ecat.com water pump heat exchanger heating
I read that you're solving the problem of production of hot water. Do you think that with the first generation of e-cats this issue is going to be solved.
Asked by Ecat.com production water pump ecat home
If you set the "H-Cat" output water temp to < 120°F (
Asked by Ecat.com water pump cop electricity
I figure that at 7000 watts for 6 months, normal tap water will deposit something over 20 pounds (9 kilograms) of solid material in the E-Cat heat exchanger. Normal developing world, often river or reused water, will be much worse. Does the E-Cat system include a deionizer system for the feed water?
Asked by Ecat.com e-cat water pump heating
In the system featured by NyTeknik (very impressive by the way), is all the liquid water coming out from the system condensed steam that has cooled down while traveling down the tube? If so, the output energy is on the high side of Nyteknik's estimates.
Asked by Ecat.com water pump
How much heat of the reactor is absorbed by the water and how much is absorbed by the solid parts of the e-cat?
Could you tell the primary flow rate of the peristaltic pump?
The test performed in Bologna october 6 was indeed impressive. However, based on the time required to attend self sustained mood, I have a question for you: According to data given by Mats Lewan in Ny Teknik it can be estimated that, if the water volume of Fat-Cat #2 had been the same as that of Fat-Cat #1, it would have taken 8.5 hours to fill up Fat-Cat #2. I must have made a mistake in my calculations. Could you please help me out here?
Asked by Ecat.com e-cat production water pump
